2010 Ford Flex Complaints

Vehicle loses power steering intermittently upon vehicle startup as well as in motion. Vehicle is then extremely hard to control without power steering. Message " POWER STEERING ASSIST FAULT" prints to the instrument cluster above the steering wheel. Turning the vehicle off and back on may resolve problem but it returns within a couple key cycles.

The contact owns a 2010 Ford Flex. The contact stated that while driving at an undisclosed speed, the brakes seized. There was no warning light illuminated. The contact was unable to pull to the side of the road. The contact stated that the vehicle responded as needed after waiting for a while. The vehicle was taken to an independent mechanic, where the brake master cylinder, the brake booster, the vacuum pump, the brake calipers, the brake check valve, the brakes lines, and the brake pedal sensor were replaced. Additionally, the ECM was replaced and reprogrammed; however, the failure persisted. The contact stated that the failure occurred when the brake fluid was hot after driving 15-20 miles. The dealer was not notified of the failure. The vehicle was not repaired. The contact related the failure to an unknown recall. The manufacturer was notified of the failure and a case was opened. The failure mileage was approximately 102,000.

The contact owns a 2010 Ford Flex. The contact stated while driving 50 MPH, the steering wheel became firm, and the vehicle lost motive power. The contact pulled over to the side of the road and was able to restart the vehicle after 3 attempts. No warning light was illuminated. The vehicle was taken to an independent mechanic to be diagnosed. The contact was informed that the failure was due to the oil mixing with the coolant. The manufacturer was made aware of the failure and determined that the vehicle was not under warranty. The failure mileage was approximately 148,000.

While driving car suddenly losses power and the wrench light comes on. Loss of power with the car transmission wont move the car at all. have to pull over and turn off car about 5min then start it back up and now everything works with no codes. Happened 3 times.VERY DANGEROUS BECUASE CAR LOSSES POWER AND CARS BEHIND YOU ALMOST HITS YOU.

While driving at 65mph, vehicle started to accelerate funny and cel came on. was getting on the freeway and the vehicle overheated and CEL light came on. I was able to safely pull over before the vehicle died. Got vehicle towed to my home and when engine oil was checked, it was discovered that there was coolant in the oil. Took to a local shop where it was determined that the water pump had failed and dumped all of the coolant into the oil pan. Estimated cost of repair with labor is $5,000. Failure mileage was ~192,000. The oil was in good standing and gold in color 12 hours prior and was only driven ~45 miles at highway speeds before the failure happened. From what I can tell, this was a catastrophic failure of the water pump bearing seal that happened almost instantaneously. This needs to be looked into, as the repair bill does not match the issue. A water pump repair should not cost more than the vehicle.