2013 Ram 3500 Complaints

The contact owns a 2013 Ram 3500. The contact stated that while attempting to sell the vehicle, the contact discovered there was a discrepancy in the mileage. The contact stated that the Carfax mileage was 47,029, and on March 10, 2015, the mileage was recorded at 49,873, and nine days later the mileage was recorded at 47,019.

The contact owns a 2013 Ram 3500. The contact stated while driving 65-68 MPH over a bumpy road surface, the steering wheel and the front end of the vehicle shuddered significantly. The contact decelerated, exited the freeway, and pulled over to the shoulder of the road. The contact was able to continue driving. The vehicle was taken to the dealer, where the contact was informed that the vehicle had experienced the death wobble. The dealer diagnosed the vehicle and determined that the upper ball joints and control arms needed to be replaced. The dealer replaced the upper control arms. The vehicle was then taken to an independent mechanic, where the upper ball joints were replaced. The contact stated that the failure recurred several times while driving. The contact stated that the upper and lower ball joints, the control arms, the bushings, and other unknown parts were replaced several times; however, the failure persisted. The vehicle was not repaired. The manufacturer was not notified...

I HAVE BEEN HAVING PROBLEMS WITH A RECALL ISSUED BY NHTSA. THE RECALL WAS V06 DRAG LINK. WHEN THE RECALL WA PREFORMED, THE ALIGNMENT NUTS ON THE DRAG LINK WERE WELDED SO THE COULDN'T COME LOOSE. I'VE HAD TO HAVE MY TRUCK REALIGNED 2 TIMES SINCE THE DRAG LINK NUTS WERE WELDED. AS OF RIGHT NOW THE NUTS ARE NOT WELDED AND THE INTEGRITY OF THE DRAG LINK IS COMPROMISED. I'VE HAD IT INTO 3 DIFFERENT INDEPENDENT REPAIR SHOPS AND EACH SAY THAT WELDING THE NUTS SHOULD ONLY BE A TEMPORARY FIX NOT A PERMANENT FIX. SINCE THE WELDING, I'VE HAD STEERING ISSUES WITH MY TRUCK WHICH IS WHY I'VE HAD IT IN THE REAPIR SHOPS. I FEEL THAT THE DRAG LINK NEEDS A TOTAL REPLACEMENT AND NOT A BANDAID FIX. I'VE CONTACTED FCA 2 TIMES AND HAVE A CASE NUMBER, #[XXX]. THE CALLS MADE WERE ON OCT. 10 & OCT 24. I'VE ALSO CONTACTED THE THE RAM DEALERSHIP IN MY AREA WHERE I GET SERVICE DONE AND HAVE "0" RESPONSE FROM THEM. I WOULD LIKE TO KNOW WHAT I CAN DO TO GET THIS ISSUE RESOLVED. THE WELDING OF A STEERING COMPONENT...

When having to brake hard, the lining of the pressure line from the pump to the hydro booster comes apart and causes the brakes to not work and the power steering to act up. The plastic lining shoots into the booster causing it to fail. They don’t make a replacement line so I was forced to fabricate one. Very expensive fix.

Truck was repaired June 2019. They welded the jam nut which made it impossible to get an alaignment.Been having a open claim with Chrysler Jeep and Dodge going on 2 years per claim #78469040 Front Suspension Track Bar Frame Bracket ( vehicle recently started to do the death wobble again)