2016 Mazda Mazda6 Complaints

The front CV axles on my car have failed. It begun with a clicking noise and vibration when accelerating. I took the car to the Mazda dealership, and they confirmed the sounds but said they weren't able to diagnose the issue and that I would have to leave my car for them to figure it out. This places my daughter and my life at risk, as well as other passengers, due to the critical role the CV axles play in operating a vehicle. More specifically, the ability to properly control my steering movement while transporting my daughter to and from school is necessary and if not present, very dangerous. An independent service mechanic has confirmed this issue and indicated that this issue has been seen in many Ford and Mazda's recently. However, there is no recall. There were no warning lights or messages prior to the problem occurring. Again, when Mazda recently services my vehicle, they conducted a full-circle vehicle inspection and did not produce any concerns.

The vehicle exhibits dangerous electronic malfunctions. A licensed technician (MV-113255) has confirmed a sporadic unintended acceleration defect where the cruise control 'decrease' button causes the vehicle to increase speed. Additionally, the vehicle repeatedly enters 'Limp Mode' in active traffic, causing a violent jerk and a total loss of acceleration while displaying a 'Smart City Brake Support' (SCBS) failure on the dashboard. An independent inspection also documented gross mechanical neglect, including loose battery terminals and a loose transmission bellhousing bolt, which may contribute to these intermittent electrical/safety failures.

The contact owns a 2016 Mazda Mazda6. The contact stated that after her husband had driven for approximately 2 hours with the seat heater activated, the passenger’s side seat overheated, and the seat started smoking. The driver stated that the seat heating element overheated and burned a hole in the seat, damaging the air bag located near the seat heater sensor. The dealer was contacted, and an appointment was scheduled. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 113,500.

My seat doesn’t detect if passanger is in seat so my air bag engine light goes on and off it was recalled and mazda supposedly cleared the issue but seems like they didnt fix it the recall properly

1) UNKNOWN. My guess: The front seats or guard rails. 2) Very seat when braking, and coming to and from a stop. Poses as a safety risk. 3) Yes, no remedy/solution was yielded. Others on forums who visited dealership stated that the dealership said it was “normal”. Despite the other side not having the issue at all. 4) No 5) No Full assessment: The issue of this complaint lies within the front seat of the vehicle. My educated guess is that there is a defect within the seat rails of the vehicle as no remedy seems to be found upon extensive research on google and various forums. Specifically, in my vehicle and may others that I have found, have issues with the driver seat feeling loose when braking or hitting the gas from a stop. Many individuals (including my close friend) have raised this to dealerships and were told that this is “normal” despite the passenger seat (or vice versa) does not have the same issue whatsoever with no remedy. I personally have tightened all possible nuts an...