2010 Mazda Mazda6 Complaints

I recently had my front subframe replaced as part of your recall, however, the rear subframe and all components attached are suffering from the exact same rust and potential component failure as the front. I was replacing my brakes today and noticed that the entire structure is on the verge of complete failure. The right rear suspension already makes unusual noises when going over even small bumps and I imagine if I were to hit a large pothole that would probably be the end of this car. I imagine all similar Mazda 6s in the Midwest suffer from the exact same degradation and it is a major safety concern. There are places where there's chunks of subframe missing because it has rusted completely through and just disintegrated.

I looked up recalls on my vehicle and it states that The 2011 Mazda6 is  part of a recall (NHTSA 19V-323, Mazda 2818I) covering 2011-2013 models for front cross member (subframe) corrosion due to insufficient rust protection . In salt-belt states, this corrosion can cause the lower control arm to detach, reducing steering control and increasing crash risk.  Key Details regarding the 2011 Mazda6 Subframe Recall: Scope: The recall affects specific 2011-2013 Mazda6 vehicles (and 2009-2010 models in a previous, related recall). Location Restrictions: Vehicles must have been originally sold in, or currently/previously registered in, 23 "salt belt" states (including CT, NY, MI, MN, OH, etc.). The Issue: The front cross member may experience severe corrosion, causing structural failure of the passenger-side lower control arm mounting point. Symptoms: Drivers may notice a change in steering alignment or a broken cross member. Remedy: Dealers will inspect the cross member and replace it if nece...

The contact owns a 2010 Mazda Mazda6. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently veered to the left. There was no warning light illuminated. The contact stated that the vehicle became difficult to steer. The vehicle was taken to an independent mechanic where it was diagnosed and determined that the engine cradle had failed and was severely rusted and needed to be replaced. The vehicle was not repaired. The dealer was contacted; however, the vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 114,000.

The airbag light is still flashing on the dashboard after the airbag recall on this vehicle was fixed. It may be related to a different recall, which is safety campaign #16V594000.

Extensive rust and corrosion in rear subframe. So severe the vehicle is unsafe to drive.