2016 Mazda Mazda6 Complaints

PCM ISSUE, passenger air bag issue, OCS wiring issue. infotainment system, transmission, and engine. Key fobs not able to be reprogrammed due to PCM issue

Driver seat is unstable and has been since I purchased the vehicle. I never got it looked at because I can't afford repairs. There was a recall for the passenger seat and I believe it would be for the driver seat as well given the driver seat stability is crucial. It rocks as if it isn't fully secure. You notice it sometimes when getting in and out the car and I became noticable when my dog decided to jump into my seat one day when cleaning my interior and I saw the seat heavily rock forward and backward. You sometimes notice it as well when coming to a stop from highway speeds the seat will slightly tilt forward. This issue has been with the car after i purchased it in 2018 but didn't notice it until a few months after the purchase.

The contact owns a 2016 Mazda Mazda6. The contact stated that while driving at an undisclosed speed, there was an abnormal sound coming from the vehicle. The transmission warning light was illuminated. The vehicle was not diagnosed or repaired. The contact associated the failure with NHTSA Campaign Number: 15V451000 (Suspension). The manufacturer was not made aware of the failure. The failure mileage was approximately 70,000.

My passenger air bag doesn’t turn on when passenger is in vehicle, sensor for air bag turns on and off as if it can’t determine if a person is on the seat. My dashboard has the SRS OCS light on. My vehicle has already been seen by Mazda to fix the recall but I am afraid to drive and suddenly air bags go off.

Fuel smell in & outside of vehicle after fuel fill, being a retired Master Technician I decided to investigate this and after removing the the fuel tank access door under the rear seat I was shocked to see that on an 8 year old vehicle the fuel sender retainer is completely rusted out. An overfill, an aggressive maneuver or small collision could prove disastrous with this condition pending! I have just ordered a replacement since I intend to repair this myself and that is only of the tank itself is not compromised when I proceed to remove the rusted out screws as well. Also after further investigation I find this is nothing new to Mazda and actually had this same condition in previous years but I assume chose not to prevent it from happening in future models. I will be attaching a photo of it.