2020 Hyundai Tucson Complaints

The contact owns a 2020 Hyundai Tucson. The contact stated that while the vehicle was receiving a routine oil change, the contact was informed that the oil pan was empty. The contact was advised to take the vehicle to the dealer. The contact was informed about a possible oil consumption test. The contact was informed that there was carbon blowing out of the vehicle. The contact stated that three months later, the oil pan was empty. The vehicle was taken back to the dealer, and engine oil was added; however, the failure reoccurred. The vehicle was taken back to the dealer where the contact was informed that the engine needed to be replaced. The vehicle was repaired. The contact stated that while driving at an undisclosed speed, the contact heard an abnormally loud sound. The vehicle was taken to the dealer where the contact was informed that the bolts for the driveshaft were missing. The contact was informed that the bolts needed to be replaced. The vehicle was repaired. The contact sta...

Dealer completed update 9C2 Theta 2 emissions update. After update, the car sputters slightly and increased noise is heard from the tailpipe. Customer returned to dealer after driving the car in different temps and noted the above complaint. Dealer verified the complaint but continues to take no responsibility for the fault on the repair receipt by writing condition is “normal” and recommending “customer to allow vehicle to properly warm up for one to three minutes prior to driving.” The last line of the service record indicates “no problem found at this time.” A template letter from Hyundai was attached to the repair record. Hyundai may be instructing dealers to not document problems in the service records assumably so they will not be liable for future litigation. It should be noted that owner was previously denied payment on their 2017 Hyundai Tucson due to lack of documentation by the dealer to prove the case with prior class action lawsuit despite years of verbal complaints to the...

The engine lost power while driving, and the vehicle entered a reduced-power mode. The check engine light began flashing, and the engine made a loud knocking noise during acceleration. A diagnostic scan showed code P1326 (Knock Sensor Signal Range/Performance). The knock sensor was replaced, and the engine oil was refilled after discovering an oil leak. The vehicle operated normally for a short time, but the same symptoms returned. The vehicle is available for inspection. The vehicle suddenly lost power while traveling approximately 70 mph on the highway, making it difficult to maintain speed and safely keep up with traffic. This created a risk of being struck by other vehicles or causing an accident. The problem has since recurred during normal driving. The problem has been reproduced multiple times. A diagnostic scanner consistently identified code P1326. The knock sensor was replaced and the engine oil was replenished, but the same symptoms returned after several trips. The vehicle...

High excessive oil consumption and premature piston ring failure leading to excessive oil consumption

Tried passing someone on the thruway, as I was about to the car jerked a bit then started decelerating. The check engine light started flashing and so did the oil light. Read the code as cylinder 3 misfire and a knock sensor. Changed the spark plugs and coil packs then checked the oil and saw there was no oil in the engine. Was told by my mechanic it’s a common problem with these Hyundai engines, it seems the rings are getting fried in the engine and that’s why it consumes oil so quickly.