2019 Hyundai Tucson Complaints

Oil consumption is at an all time high. At last oil change I had Milage 71847 on 3/8/26. I checked my oil on 4/26/26 with 73182 miles, oil was at the add mark on the dipstick which means 2 quarts was gone from my engine at about 1500 miles put on my car since the oil change. Upon reading up on this issue, it is a wide spread issue with several Hyundai models. I bought it used at a car dealship when it was only a year old, so the warranty is only for the original owner. I still owe $3400.00 on this car and I am afraid the engine will go before it is paid off.

The vehicle has had two catalytic converters replaced in 70,000 miles

The contact owns a 2019 Hyundai Tucson. The contact stated that while driving at an undisclosed speed, the vehicle unexpectedly stalled and was idling roughly. The message “Stop Driving” was displayed. The contact stated that the vehicle failed to accelerate and lost automotive power. The failure had occurred several times. On one occasion, the vehicle had to be towed. The vehicle was able to restart after several failures. The vehicle was taken to the dealer, where it was diagnosed with engine failure due to excessive oil consumption. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 59,000.

The component involved is the engine and associated knock detection system (KSDS). The system triggered a P1326 code indicating abnormal engine knock associated with a known defect condition. On February 14, 2023, while driving on the freeway, the vehicle suddenly entered reduced power (“limp mode”) and lost acceleration capability in active traffic. This created a safety risk, as the vehicle was unable to maintain speed with surrounding traffic or accelerate as needed for normal driving conditions. There were no sufficient warnings prior to the event to allow safe planning or avoidance of the loss of power condition. The system activation itself (P1326 and limp mode) was the first indication of the severity of the issue. The problem has been reproduced multiple times, with repeated P1326 events occurring after the initial incident. The condition has been inspected and partially confirmed by a Hyundai dealership. In March 2026, dealership records documented that oil contamination w...

While driving at highway speed, the engine suffered a sudden connecting rod bearing failure (Cylinder 3) with no prior warning lamps, messages, or symptoms. The vehicle made a slapping noise, a belt came off, the engine died, and would not restart. The vehicle was towed to an authorized Hyundai dealership. The driver, a [XXX] [XXX] , was able to safely guide the vehicle to a stop without injury. The dealership inspected the engine and confirmed a complete Cylinder 3 connecting rod bearing failure. The technician contacted Hyundai Techline, who confirmed the diagnosis and recommended engine replacement. The estimated repair cost is 6,500. The failed engine is available for inspection at the dealership. This vehicle is a 2019 Tucson with the Nu 2.0L GDI engine, which is covered under the E2 Class Action Settlement for connecting rod bearing defects. Hyundai Service Campaign 966 provides a KSDS software update designed to detect abnormal bearing noise before catastrophic failure occurs....