-
Steering
07/20/2026
Loss of power steering assist . Yes it is available for inspection on request. I can't steer it . It has not been confirmed by anybody yet. It has not been inspected by anybody yet. There are no warning lights on dash .
-
Structure
02/01/2024
The contact owns a 2012 Ford Explorer. The contact received notification for NHTSA Campaign Number: 24V031000 (Structure); however, the part to complete the recall repair was unavailable. The contact stated that while driving at 65 MPH on a bypass, the A-pillar exterior trim detached. The owner applied duct tape to the front windshield out of concern that the front windshield would detach. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted, and confirmed that the parts were backordered. The vehicle was not diagnosed or repaired. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 80,000.
-
Steering, back Over Prevention
06/25/2026
The contact owns a 2012 Ford Explorer. The contact stated that while driving approximately 15 MPH, the "Service Power Steering" message was displayed. The contact pulled into a parking lot, turned off and then restarted the vehicle. The failure persisted, and the power steering feature failed to operate as needed. While in reverse, the back over prevention camera display the "Service Camera - Take to Dealer" message on the screen. The dealer was contacted and confirmed that there was a recall for the failure, NHTSA Campaign Number: 14V286000 (Steering); however, the VIN was not included in the recall. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 237,000.
-
Structure
01/01/2024
Failure of the dealerships to fix recall in timely manner It’s been over two years and parts still unavailable
-
Structure
01/19/2024
The contact owns a 2012 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part required for the recall repair was unavailable. The contact stated the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted and confirmed that the part was unavailable. The manufacturer was not made aware of the issue. The contact had not experienced a failure.
