-
Structure
02/01/2024
The contact owns a 2012 Ford Explorer. The contact received notification for NHTSA Campaign Number: 24V031000 (Structure); however, the part to complete the recall repair was unavailable. The contact stated that while driving at 65 MPH on a bypass, the A-pillar exterior trim detached. The owner applied duct tape to the front windshield out of concern that the front windshield would detach. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted, and confirmed that the parts were backordered. The vehicle was not diagnosed or repaired. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 80,000.
-
Steering, back Over Prevention
06/25/2026
The contact owns a 2012 Ford Explorer. The contact stated that while driving approximately 15 MPH, the "Service Power Steering" message was displayed. The contact pulled into a parking lot, turned off and then restarted the vehicle. The failure persisted, and the power steering feature failed to operate as needed. While in reverse, the back over prevention camera display the "Service Camera - Take to Dealer" message on the screen. The dealer was contacted and confirmed that there was a recall for the failure, NHTSA Campaign Number: 14V286000 (Steering); however, the VIN was not included in the recall. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 237,000.
-
Structure
01/01/2024
Failure of the dealerships to fix recall in timely manner It’s been over two years and parts still unavailable
-
Structure
01/19/2024
The contact owns a 2012 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part required for the recall repair was unavailable. The contact stated the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted and confirmed that the part was unavailable. The manufacturer was not made aware of the issue. The contact had not experienced a failure.
-
Structure
08/07/2025
I received the first recall notice for this defect from Ford Motor Co. in February 2024 and took the vehicle to Sheehy Ford in Ashland, Virginia on August 7, 2025. Sheehy Ford did the required inspection and confirmed that the vehicle had defective windshield rubber molding. The inspection required that the plastic body molding on both sides of the windshield be removed, which rendered them unusable and could not be replaced. Sheehy Ford said they had ordered the necessary replacement parts from Ford Motor Co. and would notify me when they were received. I have been following up with Sheehy Ford every couple of months since August 2025 and they say the replacement parts are still not available from Ford Motor Co. It seems to me that 9 months is an unreasonable amount of time to provide the necessary parts for this Safety Recall, especially missing the plastic windshield moldings, my car is unsellable, which I would like to do.
