-
Service Brakes
07/23/2026
ABS Control module, went out while driving on the interstate , causing vehicle to go into limp mode , and almost causing multiple vehicle accidents, loss traction Control, emergency brake light, and abs warning light on
-
Service Brakes, forward Collision Avoidance
08/16/2026
The abs module on many of these vehicles has a known fault. You can’t find replacement parts, even the Jeep dealership can’t get them. Many ppl are driving around with faulty modules, on a waiting list for parts. I’m one of those people. All has been fine until I was driving toward 228 business in Angleton to turn towards Walmart. I was going about 45-48 and went to brake to slow down for the stop sign. My brakes were soft instead of firm and it locked up and skid on me. I didn’t hit anything but had someone been behind me it could have been different. It scared me. Now I’m scared to drive it and have no fix for it.
-
Service Brakes, Hydraulic
02/17/2026
The contact owns a 2012 Jeep Wrangler. The contact stated that while driving at an undisclosed speed, the ABS and traction control warning lights illuminated. The ABS, cruise control, and traction control features were disabled. The vehicle was taken to the dealer, where it was diagnosed with an ABS module failure. The contact was informed that the ABS module needed to be replaced. The vehicle was not repaired. The contact was informed that the parts were no longer being manufactured. The contact stated that the failure was a known failure with the vehicle. The manufacturer was made aware of the failure. The failure mileage was approximately 120,000.
-
Service Brakes
03/19/2025
For the past two years I have experience intermittent problems with my Jeep ABS system, I ordered the replacement module part # 68145835AE from an authorized dealership on April 2025, and paid $697.39 after more than a year on back order the sales representative told me to cancel the order because they did not have any information form Stellantis North America on when the part will be available. This is the second complaint I filed with NHTSA in a year and I plan to go up to the President if I have to since this is safety concern.
-
Engine
11/29/2024
The engine's cylinder head/valve train has failed internally, allowing combustion gases to enter the cooling system — confirmed via a chemical block test performed by a master automotive technician on November 29, 2024, which verified combustion gases present in the coolant. This is a widely documented defect on this engine and model year, related to valve seat erosion in the cylinder head. Symptoms first appeared in June 2018 as an unusual higher-pitched, stressed sound from the engine. Over time this progressed to recurring, confirmed misfires on cylinders 1, 2, 3, and 5 (diagnostic codes P0300, P0301, P0302, P0303, P0305) and a mixture control fault (P219B). The check engine light has intermittently stayed illuminated for months at a time, then gone off for extended periods while the same fault codes remain stored and confirmed by a diagnostic scanner — currently the light is off but the codes persist. The vehicle frequently runs rough enough that the engine must be turned off and...
