-
Engine
06/27/2021
The contact owns a 2005 Jeep Wrangler. The contact stated while driving approximately 65 mph, the vehicle loss motive power. Several gauges became inoperable with unknown warning lights illuminated. The contact pulled over and waited approximately 15 minutes before the vehicle was restarted. The vehicle was towed to the dealer but was not yet diagnosed or repaired. The ignition switch was replaced. The manufacturer was not made aware of the failure. The approximate failure mileage was 66,666.
-
Electrical System, engine
06/27/2021
Engine failed, speedometer, tach went to 0, all gauges went to 0, power steering failed after I declutched and then coasted to a full stop (power brakes failed but still had some brake input) safely on the shoulder of an off ramp. (This not the first time this has happened, however it was the first time pulling a full trailer, so I drive as if it could happen again) Vehicle was at Branhaven Jeep in Branford, CT last July @ 64429 miles... they were unable to duplicate. It is now at Gengras Jeep in East Hartford, CT, same story. I've asked Gengras to replace the ignition switch again. I have the ignition switch from Branhaven which I found the copper plate worn off to steel and evidence of arcing on the contacts
-
Fuel/propulsion System
10/09/2018
At every fuel fill up, gasoline splashes back out onto the vehicle, the person filling the vehicle and creates a very unsafe puddle of gasoline on the ground. There is never a time that it does not happen. I would be readily available to make my vehicle available for inspection of this concern. Chrysler has issued recalls for this exact problem on several of their vehicle models all within the same time period of manufacturing. The fuel tank inlet check valve is a widely known and dangerous issue that should be seriously considered to repair the remaining vehicles on the road with this problem. It has been documented by numerous owners of Jeep Wranglers from 2005-2006 while the same issue forced a recall of the same Jeeps in later model years, 2007-2008. The Jeep has been inspected by a certified mechanic where I was notified of much of this information. With the amount of gasoline that spills out and the motorist re-enters their vehicle, there could be a static charge that could i...
-
Engine
06/04/2006
The camshaft sensor upper bushing does not get lubricated seizes up causes camshaft to wear out. In my jeep I replaced three of them on the inline 4.0 6cyl. I only have 66,660 miles on my jeep. June 4, 2021.
-
Electrical System
10/15/2020
ECU STOPED WORKING NO REASON.
