2018 Jeep Cherokee Complaints

  • Power Train 03/05/2026

    I am filing a safety complaint regarding Safety Recall 01C (NHTSA 25V-011) and the handling of my vehicle by both the dealership and Stellantis. My vehicle exhibited fault codes and conditions consistent with the defect described in Recall 01C, including: DTC C1477-4B (Transfer Case Clutch Over Temperature) DTC C1440-64 (Transfer Case Clutch Pressure Sensor) Documented drivetrain control module failure status (“TestFailed: True”) Excessive clutch temperature readings exceeding 400°F These are consistent with PTU-related failure conditions the recall is intended to detect and address. Despite this, the dealership concluded that the PTU was not the cause and instead replaced the rear differential. I repeatedly requested written documentation explaining how the PTU was ruled out and how the rear differential was determined to be the root cause. This was not clearly provided. Additionally, the recall remained marked as “incomplete” for over a month while the vehicle was in the dealers...

  • Power Train 05/01/2026

    The contact owns a 2018 Jeep Cherokee. The contact stated that while driving at an undisclosed speed, the 4WD warning light illuminated, rendering the 4WD inoperable. The vehicle automatically switched to the Rear Wheel Drive mode. The vehicle was taken to both an independent mechanic and the dealer, who determined that the PTU had failed and needed to be replaced, but the part was on backorder. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 25V011000 (Power Train); however, the VIN was not included in the recall. The manufacturer was not made aware of the failure. The failure mileage was approximately 110,000.

  • Power Train 05/01/2026

    The contact owns a 2018 Jeep Cherokee. The contact stated that while driving at an undisclosed speed, the vehicle failed to shift properly when the accelerator was applied. The contact was unaware of any warning lights illuminated at the time of the failure. The vehicle was taken to the dealer, where it was diagnosed that the power transfer unit and drivetrain had failed and needed to be replaced. The vehicle was repaired. The manufacturer was made aware of the failure, and a reimbursement case was opened. The failure mileage was approximately 99,477.

  • Electrical System, exterior Lighting 12/31/1969

    When the running lights and headlights are set to Auto, moving the lever to High Beam causes the lights to go out. I have been asking the dealer and trying to find a solution since buying the car new, but no recall had been issued for my VIN and the dealer will not correct the problem with a recall specific to my VIN and year/model. There is a known issue with the Smart Lighting Module that prevents the High Beam from activating and shuts off the headlight in the Auto position, and a software update has been issued for the newer models, but not for the 2018 Cherokee with the same software.

  • Power Train, electrical System 03/02/2026

    While driving, often at highway speeds, all of the lights on the shifter will light up and the dash will display "Service Transmission." I took it to the dealer several times and their response has been that it is a software issue that they do not have a fix for and that I should stop the car, turn the engine off, open and close the door and then restart the car. This does temporarily reset the display but doing this on the highway poses a safety problem in trying to get to the shoulder in traffic.

View Complaints for Other Jeep Cherokee Years