2006 Ford Escape Complaints

This 2006 Ford Escape Hybrid, and all first and second generation (2001-2012) Escape models, were designed and built with a significant, known defect in the mating area and materials used for the rear floor pan, rear sub-assembly/rails, and rear inner fender liners/upper shock absorber mounts, all made of pressed steel. The design of the components renders them subject to trapping road debris/salt/contaminants, and the inferior steel used oxidizes quickly, resulting in perforated areas of substantial rust. In our 2006 model, the right rear inner fender liner was completely replaced, and the rear subassembly/rails were welded, in 2013 with new Ford parts. By May, 2018, it had to be repaired and welded again. As of May, 2013, five years almost to the day, it has again rusted and separated. As this hybrid Escape carries a 600 pound battery between the rails in the rear of the vehicle, this is a substantial, dangerous defect affecting potentially millions of cars manufactured over a decade...

The contact owns a 2006 Ford Escape Hybrid. The contact stated while driving at an undisclosed speed, the vehicle stalled. The vehicle was taken to an independent mechanic, who informed the contact that the brushless Motor Electronics Coolant (MEC) pump needed to be replaced. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 14V526000 (Hybrid Propulsion System). The manufacturer was not made aware of the failure. The failure mileage was approximately 150,000.

The contact owns a 2006 Ford Escape. The contact stated while driving approximately 40 MPH, the accelerator pedal was depressed; however, the vehicle started to lose motive power. Additionally, the contact stated that the accelerator pedal remained floored after being depressed. The contact drove to a parking lot and turned off the vehicle. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was 118,199.

The contact owns a 2006 Ford Escape. The contact stated that while pulling into the driveway, the check engine warning light illuminated and there was smoke coming from under the hood. The contact parked the vehicle and noticed that the smoke had increased. The contact stated that as he exited the vehicle, the smoke became darker. The contact stated that upon looking through the passenger's side wheel well, he saw flames under the engine compartment. The contact then walked away from the vehicle. The contact stated that the entire front end of the vehicle and dash had significantly burned and melted. The contact was able to extinguish the fire with the assistance of the fire department. A fire department report was filed. There was no injury sustained. The vehicle remained at the residence. The dealer was not notified of the failure. The vehicle was not diagnosed nor repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA hotline for assistance. The...

2006 FORD ESCAPE. CONSUMER WRITES IN REGARD TO RUSTED OUT REAR SHOCK MOUNTS.