2013 Toyota Tundra Complaints

Cam tower leaks oil on the heat shield below it. Cam tower uses rtv rubber seal instead of a gasket. The rubber deteriorates and the cam tower leaks engine oil on the heat shield. Not clear why Toyota used form in place rubber material instead of real gasket. Repair however is major. Need to take apart engine to repair. Major repair. The fix is to replace it with the same material again. Which is subject to deteriorate again. This is a know issue on the 5.7 L engine. Toyota seems to have its head in the sand hoping they shouldn’t be forced to recall. However this is a know design flaw resulting in leaking oil on the heat shield. With no Toyota recommended new design or parts repair except to do it all over again and hope it doesn’t leak again it’s ridiculous. . Terrible design that leaks oil on the heat shield.

Plastic piece and spring have ejected from the seat belt receiver and now the receiver does not latch on to the seat belt when it is inserted into the receiver (driver side but could happen to any/all). The seat belt no longer buckles.

The contact owns a 2013 Toyota Tundra. The contact stated while driving approximately 70 MPH, the vehicle and steering wheel started shaking. The contact pulled over safely and inspected the vehicle and noticed there was power steering fluid leaking from the vehicle. The vehicle was taken to an independent mechanic who diagnosed the failure as an engine leak. There was initially no warning light illuminated; however, after arriving home, the check engine warning light illuminated. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 122,000.

In 2017 while driving home from a restaurant with my husband, mother and sister when on highway 60 in Show Low Arizona we started experiencing a shaking which seemed to come from the from end of the truck. Since we were only a short distance from home we slowly made our way down the side road. As soon as we turned into our driveway the truck came to a quick stop. We jumped out and found that the passenger front tire and rim had separated from the truck. A full bed tow truck came and took the truck to Hatch Toyota in Show Low Arizona. The second incident occurred last year (2021) while we were moving to Sarcoxie Missouri. My husband was on Interstate 40 just east of Albuquerque when he experienced the truck shaking and upon immediately pulling off to the side of the road noted the left front wheel and rim had separated from the vehicle. The truck was taken to the Albuquerque Toyota for repair. I am having the rims replaced at this time as I understand that after-market rims may be...

We are a surveying company with a fleet of 35 Toyota Tundra trucks. Two of the trucks in our Denver location have had the engine wiring harness chewed and destroyed by rodents in the parking lot. Each is costing $6,500 to repair. The second truck shorted out and the check engine lights came on, would not start. I am glad this did not fail while someone was driving it. Toyota uses a flexible pipe wrap over some of this wiring that is soy based; the plastic wrapped wiring is unaffected. This problem is well documented on the internet, and very common. Toyota is profiting in a big way from this design defect, and they are compromising safety by risking engine failures due to shorts. They should be forced to install hard plastic wire covers over these harness wires to prevent this damage.