-
Structure
08/10/2025
Our van has recently been having issues with the sliding doors. It has occurred while driving and the warning light as well as the warning for a door open, and the door lights have came on. Right before this occurs you can hear a click sound from the sliding door behind the driver's side as well as when you close the door, you can hear a strange sound when it closes, unlike the passenger side sliding door.
-
Structure, latches/locks/linkages
08/10/2016
The contact owns a 2016 Toyota Sienna. The contact stated that the driver’s side electric sliding door failed to properly open and close, and occasionally abruptly closed, causing a safety hazard to the occupants entering and exiting the vehicle. The cause of the failure has not yet been determined. The local dealer and manufacturer were notified of the failure, but no assistance was offered. The contact stated that the vehicle was previously repaired under NHTSA Campaign Number: 16V858000 (STRUCTURE). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was unknown.
-
Wheels
04/06/2025
Excessive outer wear on front tires
-
Latches/locks/linkages
07/15/2024
The contact owns a 2016 Toyota Sienna. The contact stated the driver-side sliding door latch failed to latch as intended. The contact stated that after several attempts, the sliding door failed to close completely. The contact stated that no warning light was illuminated. The vehicle was taken to an independent mechanic but was not diagnosed. However, an unknown part was repaired. The contact stated that the failure persisted. The contact removed the button under the sliding door to manually close the door. The manufacturer was not notified of the failure. The contact related the failure to NHTSA Campaign number: 16V858000 (STRUCTURE); however, the VIN was not included. The failure mileage was approximately 70,000.
-
Power Train
12/12/2023
After 80,000 miles have a loud whirling sound coming from rear, after inspection and online investigation found many many others with same issue, the dust cover and or o-ring doesn’t properly protect the rear bearing in the coupler. So while the fix is to remove the rear differential coupler, and replace the bearing with an improved version, seems Toyota has stopped supporting this, and no longer offers the improved bearing as a replacement part, but only supports replacing the entire rear differential coupling at $2000 for the part plus labor. While many have replaced the bearing without issues despite toyota not allowing it as a fix. So first it should be a recall as this is an obvious defect effecting thousands, but then to gouge owners for thousands when the fix doesn’t require a complete replacement of the rear differential coupling assembly.
