2005 Subaru Outback Complaints

P2138 code. Gas pedal stops responding to inputs. Car goes into limp mode and managed to get car off the road. Shut off and waited 5 minutes, restarted and it works again. Associated P0500 code also present. First time this has happened on this car.

The contact had received several recall notifications of an air bag recall for a 2005 Subaru Outback. The contact never owned the vehicle and requested to be removed from the recall distribution list. The manufacturer was contacted and advised the contact that the removal request could not be processed without the complete VIN. The contact had provided a partial VIN.

See attached document for complaint.

Vehicle brakes failed while driving, the brake pedal went to the floor and almost caused a serious car accident. Yes, vehicle and brake lines are available for inspection upon request. My safety, the safety of others and more importantly my life and the lives of others were severely threatened because of the major break failure that occurred. It is terrifying to think that I was unknowingly driving around this vehicle with an imminent accident that could happen anytime, without any warning, which could have killed me. After taking pictures of my brake lines, recording videos and doing some quick research, I called a local to inspect my brake lines. I told them the scenario that I experienced and reported to them that my brake lines were covered in rust. I told them that I found out my vehicle had a recall remedy done on the brake lines in 2017, which is before I owned the vehicle. I told them that the rust and corrosion was in the same spots that were supposed to be fixed in the recall...

There should be a recall for front suspension on this vehicle if not the entire suspension. Mine has been garage kept since day 1, is in showroom condition, not driven in salt on roads during snow, therefore no reason for the suspension to be in this condition. In 2019 at 74,000 miles I had to have the entire front end suspension all components replaced at a cost of over $2,500 USD the suspension was also causing what others refer to as "drifting" under any road driving conditions on dry or wet pavement at any speed above 30mph and would and still does after having the entire suspension replaced, drift, unstable, and when the original suspension was replaced even after being flawlessly maintained the suspension components from the factory were severely worn and including rubber gaskets, sway bars, etc and appeared to have a rust or corroded appearance in spite of the vehicle never being driven in weather during snow when most areas would place salt on roads which is a primary cause of...