2011 Mercedes-benz GL-Class Complaints

Air compressor fail

My tires were wearing on the inner sides, replaced tires and had a 4 wheel alignment. Rear wheel alignment could not be corrected due to severe rusted and corrosion. Mechanic said the rear sub frame needs replacing. They advised that I do not drive the vehicle because it is not safe. I have the wheel alignment printout. I only have 48,000 miles on vehicle and keep up with maintenance. The Mercedes Benz dealer quoted 8,000 to replace. This issue was known by Mercedes Benz which they did not disclose to owners. Very dangerous.

The contact owns a 2011 Mercedes-Benz GL550. The contact received notification of NHTSA Campaign Number: 22V315000 (SERVICE BRAKES, HYDRAULIC). The contact stated that while reversing, the brake pedal was depressed with an abnormal hissing sound coming from the brake pedal. The contact stated that the sound was audible since the vehicle was purchased in 2019. The local dealer was contacted. The manufacturer was made aware of the issue. The contact received a vehicle compliance letter from the manufacturer, which stated that a mobile mechanic could be sent to the residence to inspect the vehicle, and the dealer would offer tow service. However, when the dealer was contacted, the dealer refused to assist the contact with the tow service or a mobile mechanic. The contact stated that the failure persisted. The vehicle remained at the residence and had not been driven due to the failure. The failure mileage was approximately 22,000.

The contact owns a 2011 Mercedes-Benz GL450. The contact stated that while driving at various speeds, the message for brake and traction control failure was intermittently displayed, causing the cruise control to disengage. The vehicle was taken to the dealer and was diagnosed with ha ydraulic control unit failure. The contact was informed that the hydraulic control unit needed to be replaced. The vehicle was not repaired due to the cost. The contact related the failure to two undisclosed recalls; however, the VIN was not under recall. The manufacturer was not notified of the failure. The failure mileage was approximately 120,000.

- The hard brake lines from the going to the rear axle ruptured during light braking. The corroded sections have been removed and are available. - I had no indication of a problem until I went to stop the vehicle. I was able to slow the vehicle down but could not keep it from moving forward with out being in neutral. Had there been another car in front of me or in traffic, I would not of been able to stop. - The problem cannot be reproduced by a dealer, since the corroded and ruptured section of the lines had to be replaced. There has been no inspection of the issue since no accident occurred. - No warning lamps or any indication of a problem until the brake pedal was applied. Pedal was firm then suddenly went to the floor (repeatedly). Only until all the fluid drained from the reservoir did the "brake" light come on.