-
Suspension
09/29/2021
The contact owns a 2002 Chevrolet Express. The contact stated while driving 65 MPH, she heard an abnormal loud banging sound coming from the rear end of the vehicle. The contact stated that the passenger’s side rear axle detached from the vehicle, causing the tire to detach and roll away. The contact did not sustain any injury. The vehicle was towed to a tow lot. The dealer and the manufacturer were not notified. The vehicle was not diagnosed nor repaired. The approximate failure mileage was 100,000.
-
Suspension
02/11/2021
2002 CHEVROLET EXPRESS 3500. CONSUMER WRITES IN REGARDS TO BROKEN DRIVERS SIDE SPRING LEAF. *LD THE CONSUMER STATED AFTER A POTHOLE BROKE THE SPRING LEAVE, IT WAS DISCOVERED THAT SPRING LEAF WAS INCORRECTLY INSTALLED BY THE FACTORY. *JS
-
Structure
07/01/2018
THE SIDE HINGES SEIZE UP AND BREAK. IT THROWS THE DOOR ALIGNMENT OFF AND I AM NO LONGER ABLE TO COMPLETELY CLOSE THE FRONT SIDE DOOR AND IT KEEPS THE PASSENGER DOOR FROM OPENING ALSO. THIS IS A CONTINUEING PROBLEM CHEVROLET HAS WITH THEIR EXPRESS VANS. IT IS A DESIGN PROBLEM AND ALSO CHEAP MATERIALS CAUSED IT TO RUST AND SEIZE UP AND THEN BREAK THE HINGE, THE HINGE IS WELDED ON. VERY EXPENSIVE TO HAVE REPARED. IT IS DANGEROUS AS PEOPLE CAN NOT GET OUT OF THE VAN. CHEVROLET NEEDS TO OFFER AN INEXPENSIVE FIX FOR THIS.
-
Service Brakes
11/27/2016
2 DAYS AGO I WAS DRIVING ON THE BALTIMORE BELTWAY TRAFFIC MADE AN ABRUPT STOP I HIT MY BRAKES AND THE PEDAL WENT TO THE FLOOR LUCKILY I WAS IN THE RIGHT LANE AND COULD USE MY PARKING BRAKE AND DOWNSHIFTING TO GET OFF THE ROAD. I WAS ABLE TO GET OFF THE NEXT EXIT AND TAKE BACK ROADS HOME USING MY PARKING BRAKE TO STOP. *TR
-
Seat Belts
08/19/2015
REAR SEAT BELTS FAIL TO LOCK MY VEHICLE IS A CONVERSION VAN BUILT BY DEBUT IN SAGINAW MICHIGAN. RECENTLY MY GRANDCHILDREN NOTICED THAT THE REAR SEAT BELTS FAILED TO LOCK. THOSE BELTS ARE ON THE SEAT/BED UNIT. THE SEAT BELTS HAVE THE NAME ATWOOD MOBILE PRODUCTS ON THEM. I INSPECTED THE SEAT BELTS AND DETERMINED THAT THE PLASTIC COATING ON THE MALE END OF THE BELT PREVENTED THE MECHANISM FROM PROPERLY LOCKING IN PLACE. I CUT ENOUGH OF THE PLASTIC COATING OFF TO ALLOW THE ENDS TO PROPERLY LOCK IN PLACE. THEY WORK FINE NOW. MY CONCERN IS THAT THERE MAY BE MANY MORE VANS WITH SEAT BELTS THAT DO NOT PROPERLY LOCK IN PLACE.
