2012 Bmw 128i Complaints

Prior to August 2024, this vehicle operated with zero check engine lights or drivetrain faults. In August 2024, BMW of Pittsburgh executed federally mandated Safety Recall 23V-707, which required opening the cylinder head. Immediately following this service, the Check Engine Light began illuminating persistently.On or about October 3, 2024, an independent diagnostic scan at Bobby Rahal BMW pulled BMW Factory Code 002A89: Exhaust VANOS Camshaft Mechanism Fault (Mechanical Sticking/Flow Restriction). Technicians at Bobby Rahal BMW explicitly instructed me to return the car to BMW of Pittsburgh because they suspected the original VANOS safety recall repair was botched.On October 28, 2024, I returned the vehicle to BMW of Pittsburgh to address this issue. Their technicians opened the engine block assembly a second time, yet failed to correct the defect. Following this second visit, the check engine light continued to come on intermittently. The vehicle began suffering rough idling, difficu...

Due to BMW using plastic parts when you live in Hot and cold environments the plastic begins to mold to other plastic parts and pvc diaphragms tear rather easy causing rough idle , stalls and can cause over revving and send a car into another car while in gear. The cheap plastic cause oil leaks and when oil gets low cause engine failure as well.

On February 25, 2026, BMW of South Miami performed the VANOS safety recall repair on my vehicle. The repair order documented that VANOS bolts were missing and retrieved from the engine oil pan and that VANOS components were serviced. Within approximately 24–48 hours of picking up the vehicle, the check engine light illuminated and the vehicle began operating abnormally, including rough idle and irregular shifting. The vehicle stored diagnostic fault code P054B (camshaft position timing over-retarded), which directly relates to camshaft timing and the VANOS system involved in the recall repair. I returned the vehicle to the dealership for further diagnosis. The dealership stated an aftermarket camshaft position sensor with two O-rings was installed and removed one O-ring to correct the gap between the sensor and the camshaft reluctor wheel. The faults were cleared and the vehicle was returned to me. However, the check engine light returned again the following morning upon cold start,...

The contact owns a 2012 BMW 128I. The contact received notification of NHTSA Campaign Number: 23V707000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2012 BMW 128i. The contact stated after completing an oil change at the dealer and starting the vehicle, the RPM started fluctuating. The contact stated that after coming to a complete stop at a traffic light, the RPM fluctuated rapidly and the vehicle decelerated while driving. The dealer was notified of the failure and advised the contact to take the vehicle back to the dealer for a diagnostic test. The contact was able to drive to the dealer at a slower speed. The dealer diagnosed that the VANOS (Variable Nockenwell Steuerung) system needed to be replaced. The dealer informed the contact that the failure was a manufacturing defect; however, she would be responsible for the cost of the repair. The manufacturer was notified of the failure and informed the contact that they could not assist since an unknown recall was converted to an extended warranty repair which had expired. The vehicle was not repaired. The failure mileage was 79,769.