-
Power Train clutch Assembly
26/06/2013
Volvo Trucks North America (Volvo) is recalling certain model year 2007-2014 VAH, VHD, VNL, VNM, and VT models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch from automatically disengaging when the brake is applied.
-
Service Brakes, Air supply quick Release Valve
12/11/2010
VOLVO TRUCKS IS RECALLING CERTAIN MODEL YEAR 2007 AND 2009 VHD, MODEL YEAR 2006 THROUGH 2010 VN, AND MODEL YEAR 2007 THROUGH 2009 VT TRUCKS MANUFACTURED FROM NOVEMBER 7, 2005, THROUGH OCTOBER 30, 2009, EQUIPPED WITH AN AIR RELEASE FIFTH WHEEL. THE INVERSION VALVE ON THE FRAME MAY BE ORIENTATED WHERE CONTAMINANTS CAN ENTER THE VALVE THROUGH THE EXHAUST PORT. AS A RESULT, THE BRAKE VALVE MAY CORRODE.
-
Visibility windshield Wiper/washer motor
21/05/2009
VOLVO TRUCKS IS RECALLING 127,764 MY 2001-2008 VHD, VNL, VNM, AND MY 2005-2008 VT TRUCKS. A SEAL MAY FAIL ALLOWING WATER AND CONTAMINANTS TO SEEP INTO THE WINDSHIELD WIPER MOTOR.
-
Steering gear Box shaft Sector
04/04/2006
ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH DANA STEERING SHAFTS, THERE IS A POTENTIAL THAT THE STEERING SHAFT PINCH BOLT HOLE MAY BE INCORRECTLY LOCATED. THE PINCH BOLT FITS INTO A GROOVE IN THE STEERING GEAR INPUT SHAFT TO ENSURE THAT THE STEERING SHAFT DOES NOT SEPARATE FROM THE STEERING GEAR IF THE PINCH BOLT COMES LOOSE.
-
Power Train driveline
11/10/2006
ON CERTAIN TRUCKS EQUIPPED WITH ARVINMERITOR RPL20 HIGH ANGLE INTERAXLE DRIVESHAFTS, AN IMPROPER SEATED OR MISSING SNAP RING CAN RESULT IN THE BEARING CUP TO SEPARATE FROM THE SLIP YOKE SUB-ASSEMBLY. THE UNIVERSAL JOINT CROSS COULD THEN CONTACT THE SLIP YOKE CASTING AND EVENTUALLY CAUSE THE EAR WORK TO FRACTURE.
