2011 Toyota Tundra Complaints

The contact owns a 2011 Toyota Tundra. The contact stated while driving 40-50 MPH downhill, the vehicle lost power steering functionality. There was no warning light illuminated. The contact pulled to the side of the road. The contact stated that upon inspecting the vehicle, there was an oil leak on the passenger's side of the steering gear onto the ground. The contact was able to drive the vehicle to the destination without power steering functionality. The vehicle was towed to the dealer, where it was diagnosed that the steering rack had failed and needed to be replaced. The dealer informed the contact that the steering rack replacement could not be covered under warranty due the part number. The vehicle was not repaired and remained at the dealer. The contact related the failure to NHTSA Campaign Number: 21E103000 (Steering); however, the VIN was not included. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 121,000.

Rack and pinion is leaking oil.

The contact owns a 2011 Toyota Tundra. The contact stated that upon loading the bed of the truck, a worker stepped on the bed and his foot went through the bed. There was no injury sustained. The contact then noticed that there were four 3-inch holes located near the bed bolts of the vehicle due to corrosion. Additionally, the contact stated that the frame was corroded. The contact related the failure to TSB Number: [XXX]. The contact stated that he was an independent mechanic and had determined that the failure occurred because there was no underbody coating on the vehicle, which caused water to be trapped on the underbody. The local dealer was contacted, but no assistance was provided. Another dealer, Oakbrook Toyota (550 E Ogden Ave, Westmont, IL 60559), was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that they could not assist because the VIN...

The contact owns a 2011 Toyota Tundra. The contact stated while driving at an undisclosed speed, the check engine waning light illuminated. The vehicle was taken to the dealer to be diagnosed. The contact was informed of secondary error in the injection system caused by water intrusion. The contact was also informed that there was a recall on the vehicle however, the vehicle had exceeded the mileage limitation. The vehicle was repaired but the failure persisted. The manufacturer was not made aware of the failure. The approximate failure mileage was 219,000.

Horn stopped working right after I bought this truck from a dealer. I did some research on why it stopped. I was told and also read that it was the air bag clock spring. This controls the air bags and horn and other components. What it is the clock spring was installed by Toyota that had a bad spot on it. This causes the wiring harness to start rubbing and cutting into the wires. Would cause the horn to stop working and the air bags not to work and other things that is wired to this harness also. This should be a safety concern, and Toyota needs to recall to fix. Read that the 2011 Toyota's was bad for doing this. Costing the customer about $800.00 to fix. I have the truck about 3 months. Might be the reason it was traded in. Works some times and doesn't work. I am worried the air bags will deploy if not fixed. Please check into this. I would like to know what you find out before I spend the money to get it fixed On Social Security and don't have that much money in hand to have fixed.