2013 Mitsubishi Outlander Complaints

On Dec 8,2023 our mitsubishi outlander shut off while being driven. When this occurred multiple warning lights come on including, service engine immediately, engine overheating (which it was not) and multiple other lights. It was towed to the dealership where they told us the ECU is bad. Mitsubishi no longer makes the part. They have also told us this is the 3rd vehicle in the last month with the same issue. Car had no power/electrical /engine issues prior to this event. Mitsubishi is offering no solution to fix the issue. Luckily when the car shut down we were driving at a low speed in a neighborhood. If this had happened on the freeway it could have been very dangerous. We now have no car, no possibility of repair and no answers to why this happened without warning.

My electrical system and/or computer brain is not operating properly. About a year and 1/2 ago the low beam passenger light stopped working. I had the bulb replaced at Walmart. 2 months later it went out again. Walmart checked and said the bulb was not the problem so I went to Firestone and was told the wiring was melted. Firestone said my options were to replace the entire harness or pig tail the low beam. I opted for the pig tail. A few months later I had issues with slow starts as if my battery was being drained. A few weeks after that my drivers side low beam started working intermittently. Then went out completely. I went to Gillman dealership in Schertz, TX (330 miles from my home) who said the bulb needed to be replaced which they did. A month later the drivers low beam is out again. Firestone says the wiring has melted on that side too. This time I asked them not to fix it because I wanted to go back to the dealership to repair. 1 week later my battery died twice and the pass...

hello: i purchased this vehicle last nov. the rear hatch was opening fine," but after a couple of months it has stopped and the only way to open it," is from the lever on the inside. you have to use a screw driver or prying tool of some sort to remove the cover in order to get to the lever and you have to lay the back seats down and crawl back there to get to this. i've spoken to other owners who have the same issue. they've had to replace either and or both the actuator and the handle tailgate lock release mechanism. the handle tailgate lock release mechanism is electrical and is susceptible to water getting into it and corrodes the electrical parts. it sits mostly flush one the outside of the hatch where water can get too it. i feel this is a safety issue incase of an accident or emergency if it is imperative to gain access. also the design of the so called emergency release lever is terrible. some people might not have a screw driver or something to pry with in order to remove the c...

The contact owns a 2013 Mitsubishi Outlander Sport. The contact stated that while driving at various speeds, his wife indicated that the vehicle was not driving in a straight line. Upon inspection, it was discovered that the front driver’s side suspension lower control arm had fractured due to subframe rust and corrosion. The local dealer and manufacturer were notified of the failure, but no assistance was offered. The vehicle was not yet repaired. The contact stated that the vehicle was previously serviced under the NHTSA Campaign Number: 20V279000 (Suspension) but the failure occurred. The failure mileage was 140,000. The contact stated that the subframe was repaired two years ago under recall but there is rust and corrosion again.

Airbag service system light is on In my car and the codes ran and it popped up SR-14-001 they gave me paperwork saying its a recall on my driver seat mounted airbag wiring has been improperly installed. Dealership is saying its not a recall.