2013 Mazda Mazda3 Complaints

The Brake Pedal consistently malfunctions, even after the replacement of the master cylinder (by independent service center). The master cylinder does not hold pressure due to a faulty ABS control unit (which, when Mazda was contacted, said that part was on backorder until September). If the manufacturer knows this is an issue and can't supply the part due to so many replacements needed in their vehicle, why is there no recall? There is no warning to the driver on the dashboard of this issue and has causes repeated issues while breaking.

There seems to be a lot of people who own 2012 and 2013 Mazda 3 Sedans (with SKYACTIV-G 2.0L and Halogen Type Headlights) that are dealing with the same issue I am dealing with myself. I have just purchased a used 2013 Mazda 3 with Skyactive Technology and I noticed that when I was braking the headlights would pulse on and off and would continue while I braked. I have been told there is a TSB on this issue (attached) and Mazda is well aware of this happening. This concern is caused by inadequate alternator output controlled by the PCM when the battery is under a heavy load. They are to the point now of charging people for a doing the TSB on the car that is causing the problem of the alternator not producing the proper wattage to support both the headlights and the brake lights at the same time. There are numerous online forum entries that speak of this issue with 2012 and 2013 Mazda 3's. I am very concerned that my headlights may stop working which could result in my death or the...

Transmission Control Module malfunction. The AT light came on and the car made a jerking motion and a clunking noise. It lost power and would not shift which is very dangerous in moving traffic. It put me at risk for getting hit by another vehicle not expecting the abrupt change in speed by my vehicle. The check engine light is now lit up. There were no warning lights before the vehicle’s transmission malfunctioned. A code came up on the vehicle when tested. U0101 lost communication with TCM. From what I have read, researched, and have been told this issue is very common for certain years of Mazda 3’s including mine.

The contact owns a 2013 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 16V644000 (Structure) however, the part to do the recall repair was not yet available. The local dealer was contacted, and the contact was informed that the part for the recall repair was not yet available. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

All my seatbuckels are tearing. I thought it could of been my dog, but I a certain I did not give up my seat or let him drive. My driver side is also tearing. I noticed the buckle catching when securing it, and now it has moved past snag and had a quarter inch tear that it catches on. The buckle is not wide enough for the belt. The belt is no longer able to constraint as good as when it was whole. Unknown