2010 Jeep Commander Complaints

ENGINE FIRE UNDER NORMAL OPERATION

My jeep will not crank sometimes...the key will not turn. The ignition control module seems to be a problem.

Started the vehicle by inserting the key fob. Turned the key and the vehicle dash lit up and went out immediately. Tried to turn the key again and nothing happened. Could not turn the key and it was difficult to remove the key fob from the ignition.

The engine failed while driving at major intersection. Multiple individuals had to assist and avoid causing an accident. After a week at diagnostic Jeep service department, techs determined compression failure in cylinders 2 and 4 with 0 psi. There no codes or check engine lights other than a brief blinking right before failure.

The electrical system of my car malfunctioned intermittently causing lights, ac, and the engine itself to go off and on in the middle of the freeway. There was a recall on the 2010 Jeep Commander (same as my car) for faulty electrical system, yet my VIN was excluded. I believe it should have been included in the recall and this faulty electrical system was the cause of multiple repairs done at my expense to the tune of a couple thousand dollars. I ask for a query into this. The electrical system is the nexus of a car’s mechanical system and if not functioning correctly causes all else to eventually fail. The lights would not turn off after I turned them off, removed keys, and exited vehicle. Various lights would flash on the dashboard then suddenly disappear not providing enough time to read them. Many or all dashboard lights and AC would go out intermittently sometimes reappearing shortly later. Sometimes the car would shock me while driving on the freeway and therefore poses a safety...