2013 Hyundai Veloster Complaints

Ac selector switch burnt up

The car goes into limp mode in the middle of driving on the interstate or usually at higher speeds and loses speed quickly. This has put me at high risk for accidents when traveling between cities and has left me stranded on dangerous parts of the interstate at times. I have taken it to my Hyundai dealer I bought the car from and they said there is a knock in the engine and the whole engine would need replaced and I cannot afford that ($12k) but the car only has 125k miles on it and I want to keep it for as long as possible because it’s my baby. I do not think it has been inspected by anyone but my dealer yet but I am willing to let anyone look at it in order to get it fixed without paying an arm and a leg. The car did have some issues prior to this issue that were recalled and fixed, but this happened out of nowhere and when it does happen the engine light flashes and it goes into limp mode. The light currently stays on because of the O2 Sensor though, but that is not a big issue. I h...

As my [XXX] son was driving, his car, out of nowhere, stopped working and the steering wheel became incredibly hard to turn. It put him and other vehicles around him at risk as he was doing 50mph and his car suddenly stalled. No warning. No dash lights. It was hard for him to pull over to safety. We replaced the battery and tried to restart the car, then the engine started smoking. We immediately called for a tow. Our local shop said his engine seized. We then towed it to Hyundai and they confirmed the same thing, "it definitely locked right up." The car has been well taken care of, no warning signs prior to engine failure, no warning lights, etc. His car is also under 100k miles. There is literally no reason for an engine failure. In 2019 there was a NHTSA Recall 19V204, Hyundai Recall #182 ECU Software update; this was supposed to fix the issue but here we are... the engine STILL BLEW. Hyundai is refusing to help. They won't do anything. There's known issues with Hyundai's 1.6 GDI t...

I am writing regarding a serious safety issue with my 2013 Hyundai Veloster, purchased new. Over the life of the vehicle, I have replaced the manual AC/heat control head three times due to repeated failure. During the most recent installation, I left the trim panel off to monitor the wiring harness and found it becomes extremely hot while operating. A local repair technician examined it and immediately advised me not to use the heating system due to potential fire risk. Research specific to my vehicle shows documented issues including blower control overheating, burning smell/smoke, burned internal contacts, wiring harness heat damage, and repeat control failure. These match exactly what is occurring with my car. I previously spoke with my dealership’s parts department and was told there may be known concerns involving the wiring harness and blower resistor. I also contacted Hyundai Motor America Consumer Affairs but did not receive assistance. After inspection, the dealership info...

"CATASTROPHIC ENGINE FAILURE & INEFFECTIVE RECALL REMEDY (NHTSA 19V-204): ​While traveling at highway speeds, with my two children and boyfriend, the vehicle went completely black. Car loss complete power, going into a limp mode( 'Loss of Motive Power') The Check Engine Light began flashing before going solid. When I was able to pull to the shoulder, I tried to start the car and noticed the radio screen was black and stayed black(before this time, the screen would some times go blank or completely black and then turn back on). Car would start and shake really hard with noise coming from engine, and then car would die. Since then I have been going back and forth with Hyundai Motors and Hyundai dealer, telling them that this is not a warranty issue, but a safety issue and they both have ignored and didn't enology this at all. This happened October 4th, 2025 Recall of 182 was completed but it failed. The vehicle is at the Dalton Hyundai dealer in Nation City. Dealer confirmed zero compres...