-
Electrical System
08/01/2000
CONSUMER RAISED HOOD; ATTEMPTED TO START VEHICLE, AFTER VEHICLE WOULD NOT START, DOUGLAS BATTERY SUDDENLY BLEW UP, CONSUMER WAS INJURED. *AK *TT
-
Service Brakes, Hydraulic, parking Brake
03/03/2002
I BELIEVE THE SUBURBAN SERIES VEHICLES HAVE A DESIGN DEFECT IN THE BRAKE SYSTEM BECAUSE THE REAR BRAKE HOSE(FROM THE BODY TO A CONNECTOR ABOVE THE DIFFERENTIAL) IS USED AS A SUPPORT FOR THE PARKING BRAKE CABLE. THE STRONGER, HEAVIER PARKING BRAKE CABLE RUBS ON THE RUBBER BRAKE HOSE, CAUSING THE RUBBER HOSE TO FAIL. THE PARKING BRAKE CABLE DOES HAVE A 2INCH METAL SLEEVE OVER IT NEAR WHERE THE HOSE AND CABLE RUB. HOWEVER, THIS SLEEVE IS NOT LOCATED WHERE THE NATURAL LAY OF THE HOSE/CABLE IS. IN FACT, THE SLEEVE HAS A ROUGH EDGE ON IT, WHICH CAUSES ADDITIONAL WEAR ON THE RUBBER HOSE. THE RUBBER BRAKE HOSE IS ALSO BENT WHERE IT CONNECTS TO THE TRUCK BODY BECAUSE THE HOSE MUST SUPPORT THE WEIGHT OF THE PARKING BRAKE CABLE. THE RUBBER BRAKE HOSE ON MY SUBURBAN WAS ALMOST WORN THROUGH WHEN I NOTICED IT. I BELIEVE THE FIX COULD BE THAT THE PARKING BRAKE CABLE BE ROUTED BELOW THE RUBBER BRAKE HOSE WITH A RUBBER DOUGHNUT BETWEEN THE HOSE/CABLE.O. *AK
-
Parking Brake
03/03/2002
CONSUMER STATES THE METAL PARKING BRAKE CABLE WEARS INTO THE RUBBER BRAKE HOSE, WHICH COULD CAUSE FAILURE OF THE BRAKE HOSE AND THE REAR BRAKES, THE RUBBER BRAKE HOSE WAS ALMOST WORN TO THE POINT OF FAILURE, THE METAL PARKING BRAKE CABLE DOES HAVE A METAL SLEEVE ON IT TO PROTECT THE RUBBER HOSE, BUT THE NATURAL POSITION OF THE HOSE AND CABLE CAUSES THE SLEEVE TO NOT LINE UP IN THE DESIRED POSITION. *TT
-
Parking Brake
03/03/2002
CONSUMER STATES THE METAL PARKING BRAKE CABLE WEARS INTO THE RUBBER BRAKE HOSE, WHICH COULD CAUSE FAILURE OF THE BRAKE HOSE AND THE REAR BRAKES, THE RUBBER BRAKE HOSE WAS ALMOST WORN TO THE POINT OF FAILURE, THE METAL PARKING BRAKE CABLE DOES HAVE A METAL SLEEVE ON IT TO PROTECT THE RUBBER HOSE, BUT THE NATURAL POSITION OF THE HOSE AND CABLE CAUSES THE SLEEVE TO NOT LINE UP IN THE DESIRED POSITION. *TT
-
Suspension
11/04/2000
UPPER BALL JOINTS WERE REPLACED 9/25/99 BY SUSPENSION PLUS IN SAN DIEGO USING MCQUAY NORRIS PARTS.. ON OR ABOUT 11/04/2000 THE VEHICLE WAS TURNING AT LOW SPEED LEFT TURN INTO A PARKING LOT WHEN THE RIGHT FRONT WHEEL COLLAPSED UNDER THE FRONT END. SUBSEQUENT REPAIR ACTION DETERMINED THAT THE REPLACED UPPER BALL JOINT ASSEMBLY HAD FAILED BY SEPARATION OF THE BALL JOINT RETAINER ASSEMBLY FROM THE BALL JOINT. THE FAILURE OCCURRED AFTER 9,000 MILES OF OPERATION. WE HAVE THE FAILED PART.*AK
