-
Electrical System
11/30/2025
When putting the vehicle into reverse the backup camera displayed an unusable red fuzzy screen. Backup camera was unable to assist in safely reversing and mirrors and parking sensors had to be used
-
Seat Belts
10/15/2025
The contact owns a 2015 Ford Mustang. The contact received notification of NHTSA Campaign Number: 25V614000 (SEAT BELTS); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.
-
Seat Belts, back Over Prevention
10/23/2025
The contact owns a 2015 Ford Mustang. The contact received notifications of NHTSA Campaign Numbers: 25V614000 (Seat Belts) and 25V572000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The dealer was contacted and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure.
-
Service Brakes, Hydraulic, power Train
10/14/2025
The contact owns a 2015 Ford Mustang. The contact stated that while driving 35 MPH and attempting to depress the brake pedal, the clutch pedal detached from the brake pedal assembly. Neither an independent mechanic nor a dealer was contacted. The vehicle was not taken to a dealer or independent mechanic to be diagnosed. The vehicle was not repaired; however, the vehicle was in the process of being repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 115,724.
-
Latches/locks/linkages
10/08/2025
The contact owns a 2015 Ford Mustang. The contact recently purchased the vehicle. The contact became aware that the VIN was included in NHTSA Campaign Number: 20V331000 (LATCHES/LOCKS/LINKAGES). The vehicle was taken to the dealer, who refused to inspect the door latch codes. The contact was informed that it appeared that the recall repair was started; however, it was not completed. The dealer stated that since the remedy was not completed, it could not be finished. The manufacturer was made aware of the issue and informed the contact to request the dealer to inspect and verify if the remedy had been completed. The dealer refused and stated that the software did not allow the dealer to inspect the vehicle. The failure mileage was 78,955.
