2009 Ford Fusion Complaints

I have recall 19S54 and called Ford. They made an appointment with Downtown Ford, Charleston, WV. The dealership said ford declined my recall repair due to not being able to get their machines to get any codes from my car. The ABS light is on. My mechanic said Ford should fix their recall. The recall says the D03 fluid must be changed to DOT 4 even if no problem found and if problem detected how to fix it! Ford declined because they can't get code reader to work on my car. They said it is a Preexisting Condition! My car is old but only has 24,800 miles and has been kept inside in a heated garage. The Downtown dealership said their hands are tied and would love to make my car safe. Their phone number is 304 344 1601. Please help me get my car fixed!!! I have called Ford multiple times and no help due to not having the codes from the dealership. Thanks!!!!

I have noticed for some time in our 2009 Ford Fusion purchased used that the brake travel was longer than it should be. This results in the need to anticipate braking quicker and react faster to allow appropriate time to slow down. In doing some research I discovered a Ford recall 19S54 which was apparently replaced by a Ford CSP 21N11. I made an appointment to have this issue addressed by a Ford dealership and they said that the CSP expired in 2022 and the vehicle is no longer covered despite the persistence of the safety issue and the fact that it has not been repaired for this known problem. With a significant issue, such as braking, I believe the expiration should be extended to allow for Ford owners to have this known safety issue addressed appropriately by Ford.

The contact owns a 2009 Ford Fusion. The contact stated while driving 35-45 MPH, the brake pedal was depressed; however, the vehicle was slow to respond. The check brakes system message was displayed. The ABS warning light was illuminated. The contact received notifications of NHTSA Campaign Numbers: 19V904000 (Service Brakes, Hydraulic) and 21V158000 (Air Bags); however, the parts to do the recall repairs were not yet available. The local dealer was contacted. The dealer completed the air bag recall and diagnosed the vehicle and determined that the brake module and HECU module were corroded. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue, but no additional assistance was provided. The failure mileage was approximately 96,970. Parts distribution disconnect.

After activation of ABS brake system, brakes became "soft" and "spongy" with permanent increased braking time. As described in safety recall 19S54, this due to to a valve in the Hydraulic Control Unit (HCU) being stuck open. I received a letter from Ford Motor Company regarding this safety recall in 2011 informing of the defect and assuring "we will correct this condition." The vehicle was taken to Koons Ford (1051 E Broad St., Falls Church, VA, 22044; 703-241-7250) on 7/5/21 for repair. However, the HCU was not replaced, which appears to be the only remedy to this problem. Instead DOT 3 brake fluid was replaced with DOT 4 fluid, according to Koons Ford. However, after subsequent activation of the ABS brake system, the brakes became impaired again in the same way as before. I returned the car to Koons Ford on [XXX]. A "one-time" repair was performed pursuant to "customer satisfaction program" 21N11, as Ford acknowledged in a letter to dealers dated 12/7/21 that numerous custome...

While i was driving and the car hits a hole if the road, and i tried to brake so i can controll the car the breakes became uresponsive for the moment and after a few seconds when i try to brake again the travel space of the brake pedal is increased a lot and is near the end, and it takes a lot before the things return to normal( so it happens only when the car try to activate te ABS system).