-
Exterior Lighting
07/04/2009
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
-
Suspension front control Arm upper Ball Joint
21/12/2004
ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH FOUR-WHEEL DRIVE (4X4), IF MOISTURE LEAKS INTO THE FRONT SUSPENSION UPPER BALL JOINT, EVACUATION OF THE LUBRICANT AND CORROSION OF THE JOINT MAY CAUSE THE JOINT TO WEAR OVER AN EXTENDED PERIOD OF TIME. THIS COULD CAUSE A CLUNKING NOISE IN THE FRONT SUSPENSION, WHICH MAY NOT ALWAYS BE HEARD BY THE VEHICLE OCCUPANTS.
-
Exterior Lighting headlights
11/05/2009
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
-
Suspension front hub
20/10/2008
SKF IS RECALLING 2,805 HUB UNITS, PART NO. BR930361, SOLD AS A SERVICE PART FOR 1997-2004 DODGE DAKOTA VEHICLES AND 1999-2003 DODGE DURANGO VEHICLES EQUIPPED WITH 2-WHEEL DRIVE & REAR AXLE ABS. DUE TO A SPECIFICATION ERROR, THE ROTOR PILOT FOR THE HUB UNIT MAY BE TOO LONG. THIS RESULTS IN THE WHEEL TO NOT BE SEATED FULLY AGAINST THE HUB FLANGE FACE DURING MOUNTING.
-
Engine And Engine Cooling
15/03/2006
CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAIN DODGE PICKUP TRUCKS AND SUVS. A SMALL PIECE OF MATERIAL FROM THE TUBE WALL COULD BE SUCKED INTO THE ENGINE THROTTLE BODY, WHICH COULD CAUSE THE THROTTLE TO BECOME JAMMED IN THE OPEN POSITION.
