2021 Chrysler Pacifica Complaints

The power steering is intermittently losing power during turns. This just started to occur within the past week so it has not yet been taken to a shop. Yes it is available for inspection. Safety was put at risk due to it being a family car with children. A quick response was necessary to prevent oversteer during correction. Apparently this is a known issue on earlier models and seems to be continuing. No warnings.

I took the van to get the safety recall done in 2026, Feb 25. For the rear view back up camera. I took it to the same dealership that I bought the car from, Jones Junction. However, upon further complications with the back up camera, this issue has never been fixed or resolved. If anything, the issue has become worse. I am unable to use my camera 98% of the time. It freezes. It goes black or is unavailable to see anything out of. It's a safety recall for a reason. I want this issue fixed. As I have been driving like this with the issue for quite some time. What are my next steps? I prefer not to have to dealer hop if I can help it. But I might have to. Is there a patch they may have to do to re-install the software for the camera? Or would they have to go and flash it again and what ever else? My true gut tells me that I dont think this specific dealership ever did the recall, correctly.

The High Voltage (HV) Battery System and associated safety isolation circuits failed. Specifically, the vehicle experienced faults with the High Voltage System Interlock Circuit (HVIL), the High Voltage Service Disconnect, and the Hybrid/EV Battery System Precharge circuit. The vehicle is currently located at a manufacturer dealership and is available for inspection. The failure of the high-voltage interlock and precharge circuits compromises the vehicle's electrical isolation safety mechanisms. This poses an immediate risk of a sudden loss of motive power. Additionally, because these faults are rooted in the high-voltage battery system—a system actively under federal scrutiny and manufacturer recalls for thermal runaway—the failure presents a severe risk of spontaneous vehicle fire, endangering occupants, bystanders, and nearby structures. Yes. The failure was initially recorded by an independent diagnostic scan tool, which pulled several confirmed high-voltage fault codes. The vehi...

Power steering malfunctioned and stopped working in the middle of driving. It works intermittently.

My 2021 Chrysler Pacifica Hybrid has a recurring hybrid/electrical defect that causes the accelerator to lose all power while driving, leaving the vehicle unable to accelerate or respond to throttle input. The vehicle remains “on,” but it cannot move under its own power and must be coasted or pulled over immediately. This has happened in traffic, including with children in the vehicle. The dealer confirmed fault code P1A21‑00 and documented that the high‑voltage system can lose its loop connection, which results in a no‑propulsion condition. They also found the HVIL high‑voltage connector loose and damaged. The vehicle was in the shop for 18 days for this issue. I picked it up on June 18, 2026, and within 24 hours the same loss‑of‑propulsion failure happened again. The vehicle is now back at the dealer. The dealer performed recall 52D and updated the BPCM software, but the failure still occurred immediately after pickup. This defect has been reproduced and confirmed by the dealership...