2014 Chrysler 300 Complaints

The contact owns a 2014 Chrysler 300. The contact stated while driving and making a turn at various speeds, the vehicle stalled. The contact stated that the vehicle failed to restart. The contact stated that the vehicle had to be completely stopped, shifted to park, depress the brake pedal, and then depress the Push-to-Start button to restart the vehicle. The check engine warning light was illuminated. The vehicle was taken to Family Toyota of Arlington, 1661 Wet N Wild Way, Arlington, TX 76011, who was unable to determine the cause of the failure. The vehicle was not repaired. The contact was concerned about driving the vehicle. The dealer referred the contact to the Chrysler. The vehicle was taken to the local dealer, where an unknown diagnosis and repair were completed, but the failure recurred. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 43, 000.

TRANSMISSION CONTROL MODULE AND VALVE BODY ASSEMBLY. There is a backorder(700) from the factory on this product and the wait is at least 3 months! This problem has been confirmed by the dealership as well as the backorder. The vehicle will not go in gear even with the engine running. The message displays as vehicle is already in desired gear even when it is not, and you cannot put it unto any gear even neutral, as it gets stuck in park!. The code is PO658, and the CHECK ENGINE light is illuminated and can happen without warning while vehicle is parked, stopped or idling so far as I experienced. The ignition will not turn off and the battery must be disconnected in order not to drain the battery. If this were to happen in traffic or or an intersection we all could have been KILLED. It has happened 4 times to us, Two times it started working on its own and Two times requiring a tow which cost me $600. Once at the dealer they charge a $140 non-refundable diagnosis fee and then can't fix...

The contact owns a 2014 Chrysler 300S. The contact stated while driving approximately 60 MPH, the vehicle stalled. The contact stated that the check engine, transmission, and traction control warning lights were illuminated. The contact pulled over and was able to restart the vehicle after several attempts. The contact had taken the vehicle to an independent mechanic who diagnosed and determined that the engine failure was related to NHTSA Campaign Number: 17V741000 (Electrical System) and referred the contact to the dealer. The vehicle was not repaired. Additionally, the contact stated that the cruise control had failed, and the light was constantly showing that the cruise control was engaged; however, the contact stated that the cruise control was not activated. The contact researched online and related the failure to NHTSA Campaign Number: 18E053000 (Power Train). The manufacturer was not informed of the failure. The failure mileage was approximately 89,000.

The contact owns a 2014 Chrysler 300. The contact stated while driving 25 MPH, the vehicle made a sudden stop with the traction control warning light and the electrical system warning light was illuminated. The contact turned off the vehicle and attempted to restart the vehicle; however, the vehicle would not restart. The vehicle was towed to an independent mechanic and the mechanic replaced the electronic throttle control system and the electronic sensor; however, the failure recurred. The vehicle was taken back to the mechanic several times because the failure reoccurred several times. The dealer was contacted and stated that the vehicle needed to be diagnosed. The manufacturer was not contacted. The failure mileage was 125,000.

I have a 2014 Chrysler 300 S the Oil Filter Housing Is Leaking on and around wiring that could cause the warm or hot oil to leak on wires and cause an electrical engine fire the Manufacturer was contacted and they stated that my Vin Number was not included with the recall that was already issued and because my Vin was not included Manufacturer refused to repair the issue