-
Unknown Or Other, engine, fuel/propulsion System
01/01/2016
WHETHER IT'S IDLING OR DRIVING SHUTS OFF I REPLACED THE FUEL PUMP AND THE WIRING HARNESSES THAT COME WITH THE FUEL PUMP AND STILL NO AVAIL IT'S CAUSED A LOT OF TIME OFF OF WORK AND A LOT OF HEADACHE I WORK FOR A REPUTABLE DEALERSHIP I WORKED ON VEHICLES FOR OVER 40 YEARS
-
Service Brakes
02/02/2018
BRAKE LINES RUSTED AND BRAKES FAILED TWICE WHILE DRIVING VEHICLE. THERE WERE NO ACCIDENTS. FIRST INCIDENT WAS THE REAR BRAKE LINE BURST. I REPLACED THE RUSTED BRAKE LINE. FRONT BRAKE LINE BURST 6 MONTHS AFTER REAR BRAKE LINE WAS REPLACED. ALL FRONT BRAKE LINES WERE SO RUSTED, I REMOVED AND REPLACED ALL OF THEM AS A PRECAUTION. THE BRAKE LINES RUSTED IN AREAS WHERE THEY WERE CLAMPED, SO THAT SALT AND DIRT COULD NOT BE CLEANED OUT. BRAKE LINES WERE UNPAINTED BARE STEEL.
-
Fuel/propulsion System
02/04/2018
WHILE REPLACING THE RUSTED BRAKE LINES ON MY SUBURBAN (SEE TRACKING NUMBER 11066863), I NOTICED THE FUEL LINES GOING TO THE FUEL FILTER WERE ALSO TERRIBLY RUSTED. IT APPEARS THE RUST EMANATES FROM THE PLASTIC CLAMP THAT SECURES THE FUEL LINE TO THE FRAME. THE TUBE NUT THAT GOES INTO THE FILTER APPEARS TO BE FROZEN WITH RUST. SALT AND DIRT ARE TRAPPED IN THE PLASTIC CLAMP AND NUT, WHICH IS IMPOSSIBLE TO WASH OUT. THE FUEL LINES ON TOP OF THE FUEL TANK ARE LIKELY TO BE RUSTED, TOO.
-
Service Brakes, Hydraulic, service Brakes
11/16/2016
TL* THE CONTACT OWNS A 2002 CHEVROLET SUBURBAN 1500. ON SEVERAL OCCASIONS, MAKING LEFT AND RIGHT TURNS AT LOW SPEEDS, THE CONTACT EXPERIENCED UNWANTED ANTI-LOCK BRAKE SYSTEM ACTIVATION WITHOUT WARNING. THERE WERE NO WARNING INDICATORS ILLUMINATED. THE CONTACT DIAGNOSED THE VEHICLE AND STATED THAT THE WHEEL SPEED SENSOR MOUNTING SURFACE ON THE BEARING NEEDED TO BE CLEANED. THE VEHICLE WAS NOT REPAIRED. THE DEALER WAS NOT CONTACTED. THE CONTACT REFERENCED NHTSA CAMPAIGN NUMBER: 05V379000 (SERVICE BRAKES, HYDRAULIC). THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 160,000.
-
Service Brakes
08/04/2017
BRAKES FAILED WHILE DRIVING 60MPH ON HIGHWAY I-476 (PHILADELPHIA PA) WITH THE FAMILY IN THE VEHICLE. UPON BRAKING TO STOP FOR TRAFFIC, THE BRAKE PEDAL WENT DIRECTLY TO THE FLOOR AND PUMPING THE PEDAL SEVERAL TIMES DID NOT RESULT IN ANY BRAKING OF THE VEHICLE. AFTER MANAGING TO GET THE VEHICLE TO A STOP ON THE SIDE OF THE ROAD, AND THEN PUMPING THE BRAKE PEDAL SEVERAL MORE TIMES, BRAKE FLUID COULD BE SEEN COMING FROM UNDERNEATH THE VEHICLE AT BOTH THE AREA AROUND THE REAR AXLE AND THE AREA UNDER THE DRIVERS SIDE SEAT. LATER, INSPECTION OF THE BRAKE LINES FOUND THEM ALL TO BE SEVERELY RUSTED. AFTER READING THAT THIS IS AN EXISTING PROBLEM WITH GM VEHICLES, IT IS GREATLY DISAPPOINTING, TO SAY THE LEAST, THAT NO NOTIFICATION OR RECALL WAS GIVEN. SUCH A SEVERE AND SCARY SAFETY PROBLEM SHOULD REQUIRE AT LEAST NOTIFICATION OF CUSTOMERS AND BETTER QUALITY DESIGN/CONTROL OF BRAKING COMPONENTS.
