2019 Chevrolet Equinox Complaints

I was driving on the freeway at 64 MPH when my Brake Assist alert appeared on my dashboard. At that time I lost assisted braking capability. I was able to steer and stop my vehicle on the shoulder of the freeway. I turned the car off and was unable to start the car again. The car was towed to the dealership where they stated “ Hi Erika, the vacuum pump on your engine seized and broke the shaft and damaged the tone ring on the camshaft, there are quite a bit of metal pieced in the engine due that that failure. Unfortunately, the solution is a remanufactured engine at the cost of $11500.00 parts and labor plus tax. How would you like to proceed?” Currently we are opting to not replace the motor. It is apparent that this is a common issue with this year/make/model of vehicle.

The Fuel Pump Control Module (FPCM) connector corroded and disabled the fuel pump system. My car's fuel system failed while driving, and I had to pull over. After further research, I found that this particular FPCM and connector are located by the rear passenger axle and are exposed to the weather elements. This makes corrosion highly likely and poses a significant security threat for drivers, as there was no warning or engine light indication until moments before the failure. This is a design flaw and should be recalled by the manufacturer immediately.

The contact owns a 2019 Chevrolet Equinox. The contact stated that while driving at an undisclosed speed, the braking system became inoperable, and the brakes unexpectedly locked up with no warning lights were illuminated. The vehicle was taken to an independent mechanic, who diagnosed the vehicle and retrieved trouble code TSB-21NA268. The contact was informed that the brake vacuum pump connected to the crankshaft had failed and needed to be replaced. The vehicle was not repaired. The dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 61,000.

Vacuum pump went out while driving down the interstate causing hard breaking. Break pedal was extremely hard to push down putting us at risk of not being able to break in time. There were on and off alerts to service breaks assist, however it was not consistently an alert. We replaced the vacuum pump and the issue seems to be resolved. The pump is not available as we tossed it in the trash.

Vacuum pump failed: On May 28th, 2025 the brake pedal on our 2019 Chevrolet Equinox became very hard along with check engine light, a "Reduced Power" notification, and "Brake Assist Failure" notification. After a mechanic inspected the engine, he found that the vacuum pump had shattered. The mechanic replaced the pump with an OEM replacement from GM. On May 11th, 2026 the same exact issue happened again. 1. The vehicle and/or part is available for inspection. 2. Anyone driving or riding in the vehicle is at risk due to the difficulty of braking. 3. The vehicle/component has not been inspected by the manufacturer since the 2nd incident.