1997 Cadillac Seville Complaints

WHILE DRIVING AND GOING AROUND CORNERS THE STEERING VEERS TO ONE SIDE OR ANOTHER SUDDENLY. THERE IS ALSO STRANGE NOISES COMING FROM THE FRONT END WHEN GOING OVER BUMPS. IF THIS HAPPENS AT A HIGH SPEED I MAY NOT BE ABLE TO CONTROL IT AND SOMETHING SERIOUS COULD HAPPEN. THIS SEEMS RELATED TO OTHER 1997 GM RACK AND PINION FAILURES THAT I HAVE RESEARCHED. WILL HAVE THE RACK AND PINION REPLACED.

1. NO INJURY, NO CRASH, WIFE COMPLAINED OF BREAKPEDAL GOING TO THE FLOOR AS SHE BACKED OUT OF THE GARAGE - I OBSERVED LARGE AMOUNTS OF BREAK FLUID IN DRIVEWAY. I INSTRUCTED HER TO GET OUT AND SHUT IT OFF- MESSAGE CENTER ALSO WARNED OF BRAKE FAILURE. 2. STEEL BRAKE LINE CHAFED AGAINST THE FRAME OF '97 SEVILLE STS - FACTORY INSTALLATION/DESIGN WITH CLEARANCE TOO TIGHT IN THE LOCATION WHERE THE LINE CROSSES OVER THE FRAME TO THE TERMINAL BRACKED AT THE REAR WHEEL - WORE THROUGH THE BRAKE LINE. I'VE OWNED THE CAR SINCE NEW AND THERE WAS NEVER A DAMAGE OR A REPAIR IN THE AREA WHERE IT WORE THROUGH. THIS IS OBVIOUSLY A VERY SERIOUS CLASS DEFECT AS THE LOCATION OF THE WEAR THROUGH IS NOT IN A SERVICE AREA OF THE CAR AND THERE IS NO WARNING OF AN EMINENT FAILURE. 3. I USED A HACKSAW TO CUT OUT THE WORN PORTION OF THE BREAK LINE AND USING COMPRESSION FITTING FROM THE HARDWARE STORE AND A NEW BRAKE LINE SECTION FROM THE AUTO PARTS STORE RE-ROUTED THE LINE AWAY FROM THE FRAME THAT CUT T...

HEADS ON 1997 CADILLAC SEVILLE (SLS) PULLED LOOSE FROM ENGINE LETTING ANTIFREEZE ENTER INTO THE COMBUSTION CHAMBER OF ALL EIGHT CYLINDERS. HEADS WERE WARPED AND HAD TO BE TAKEN OFF ENGINE AND MILLED TO REFIT TO ENGINE BLOCK. THIS WORK DONE AT LOCAL CADILLAC DEALER (SAM SWOPE CADILLAC, SERVICE MANAGER DAVE HOLLAND 502 499 5015) COST TO REPAIR ENGINE $4,999.47........I HAVE SPOKEN TO QUITE A FEW CADILLAC OWNERS AND SERVICE PERSONNEL AND THIS IS A CONSTANT PROBLEM WITH THE CADILLAC NORTHSTAR ENGINE AND ALL CADILLAC DEALERSHIPS ARE WELL VERSED IN REPAIRING THIS ENGINE DEFECT........I HAVE BEEN TOLD THAT IF GENERAL MOTORS HAD PUT STEEL INSERTS INTO THE ALUMINUM BLOCK FOR THE HEADBOLTS TO TIGHTEN INTO AT THE FACTORY THAT THIS PROBLEM WOULD NOT REPEATEDLY OCCUR! FROM WHAT I HAVE BEEN TOLD GM WAS TRYING TO SAVE WEIGHT AND IMPROVE FUEL CONSUMPTION AND THAT IS WHY THEY WENT TO AN ALUMINUM BLOCK AND HEADS.

WHILE DRIVING AT APPROXIMATELY 15 MPH THE AIR BAGS IN THE FRONT DEPLOYED INADVERTENTLY. *AK *NM

WHILE DRIVINGA ND UPON HITTING THE BRAKES ABS LIGHT ILLUMINATED. THIS WAS A RECALL.CONSUMER EXPERIENCED THE VERY SAME PROBLEM AS MENTIONED IN RECALL 97V064000 CONCERNING ECBM REPLACEMENT. *AK