2012 Toyota Prius V Complaints

The power assist braking system failed while I was driving in the rain. I was approaching a stoplight and I had to push down a lot harder and farther than I typically have to in order to stop. Luckily I was not going that fast and there were no cars ahead of me, but I stopped beyond where I had intended at a busy intersection. No warning lamps or messages had been illuminated prior to this happening. After the failure, the Brake system, ABS, and SLIP indicator lights were on and remained on when the car was restarted. An independent service center used a scan tool and found code C1391 stored in memory, indicating that the brake booster is unable to hold pressure due to an internal leak. The vehicle has not yet been inspected by the manufacturer, police or insurance, but can be available upon request.

I bought this car over a week ago for a good price, performed fine until I’m driving it home on the interstate and some abs/brake lights came on the dash. I enter my city and notice the brakes aren’t performing as tight as they were during the test drive. A few days later I take it to a local dealership to get it looked at. The brake actuator and pump had gone bad, causing this issue. It cost almost $5,000 to fix there, I couldn’t afford it so I had to only pay the $185 for the diagnostic. It’s an on and off thing, sometimes the lights go away and it brakes as it should, but most of the time the lights are on and the brakes don’t work as they should. I fear one day the brakes may eventually give out on me and cause an accident. I am available for inspection.

The hybrid system fails to enter “Ready” mode with no SMR engagement audible from the junction box. Dashboard displays ABS, brake, engine, and master warning lights. OBD codes include U0142, U0155, and previously U0073 . Rear brake lights function normally when pedal is pressed. Dealer said to pay 250$ for diagnostic and diagnosed incorrect voltage from brake light switch and quoted $348.94 to replace, but refused to proceed with open safety recall J0V / 18V684 (NHTSA 18V684000) citing inability to achieve “Ready” mode. Recall covers inverter failure leading to loss of motive power. Dealer declined to jump 12V battery or use external power to perform required software update and inverter inspection. Vehicle remains inoperable and poses safety risk due to sudden power loss potential. Component (inverter G9200-47141) available for inspection. Problem confirmed by dealer diagnostics. No police or insurance inspection. Warning lamps appeared after 12V battery replacement three months ago.

While driving 60 mph in highway, ABS, traction control and brake lights lit up and vehicle lost its effective braking power. There were no prior warnings prior to this failure. It was a sudden incident. Since it wasn't rush hour, I could safely reduce speed and bring the car to stop. Situation could have been much different if it was normal hours. After taking the car to dealership, it indicated DTC code 1391, Brake Assembly Failure. The car was fixed at dealership at cost of $3,000. When researched further, it appeared that there is broader pattern of failures. Numerous reports have been made by owners of 2010–2015 Toyota Prius, Prius PHV, 2012–2015 Prius V, 2012–2014 Camry Hybrid, and 2013–2015 Avalon Hybrid vehicles, all of which share the same brake booster pump assembly design manufactured by Advics Co., Ltd. Dealerships, including Capistrano Toyota and Claremont Toyota in California, have previously petitioned NHTSA regarding this very defect. Their 2019 letter to the agency d...

After 13 years and 112,000 the brake booster and brake booster pump went out on my car. Toyota extended the warranty to 10 years because of this issue. Now just outside of the 10 yr mark my car has this issue and Toyota will not cover it. This is a huge expense and also a major issue with this year and model of car.