2020 Hyundai Kona Complaints

Basically normal driving the car stalled. It slowed to a stall. I had to restart the car. This has happened a couple to times.

On 3/29/26 my Kona caught fire while parked in the front left side of the engine and burned completely within eight minutes. This is not an electric car. Prior to that I drove the car all day with no incident. It was later in the evening around 5:40 PM. I had driven from my house to a restaurant which is about 6.8 miles from my house. I parked my car and then my son-in-law noticed that my engine was smoking. My husband went to check to see if it was the radiator, but he noticed that it was fire and we called [XXX] . I know there are no recalls for my car, but I wanted to report it to you. The car only had 44,900 miles on it and was only serviced by West Nyack Hyundai. The last service was on 1/19/26. If you have any questions, you can email me at [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

My car was taken in as a part of recall bulletin 203 for improperly heated piston rings treated pistons rings that result in premature engine failure and possible fire on 12/5/25. The knock sensor test was performed and the KSDS software was installed. On 3/12/26 my daughter who was on the way home from a trip called because her checking engine light started flashing and the engine was knocking. We had it towed to Hyundai and they are denying service under the recall stating improper codes yet one of the codes is P1327 KSDS detection which is related to the rod bearing failure the car currently has. They are trying to make me pay $4600 out of pocket plus the tow bill when this is directly related to the recall.

My 2020 Hyundai Kona (VIN: [XXX] ) has a persistent engine stalling safety defect that matches Recall 203 (22-01-042H, NHTSA Campaign 21V301000 – Nu 2.0L Atkinson Engine Inspection and Replacement). The recall addresses improperly heat-treated piston oil rings causing cylinder bore scuffing, accelerated oil consumption, abnormal knocking, and potential engine stall while driving (increasing crash/fire risk).I first brought the vehicle to Corona Hyundai for repeated stalling while driving. They performed the recall vibration inspection and software update (Campaign 974), stated the test passed, and declared the vehicle "fixed", safe and "good-to-go" Immediately after pickup, the stalling returned worse: approximately 60-80 miles later on XX near the XXX exit (four-lane high-speed highway), the engine completely stalled at 65 mph while merging for an exit. This caused vehicles and semi-trucks behind me to swerve dangerously and very nearly collide with me. The vehicle stalled four more t...

The contact owns a 2020 Hyundai Kona. While the contact’s son was driving the vehicle on the highway at an undisclosed speed, there was a knocking sound coming from the engine and the vehicle failed to stop as intended. The gear shifter was shifted into neutral(N) and restarted; however, the engine failed shortly afterwards, and the vehicle was unable to restart. No warning lights were illuminated. The vehicle was towed to an independent mechanic, where it was diagnosed with piston rings failure and low engine oil. The vehicle was not repaired. The manufacturer was notified of the failure, where it was confirmed that the VIN was included in NHTSA Campaign Number: 21V301000 (Engine); however, the recall repair was already performed. The approximate failure mileage was 108,000.