2015 Chevrolet Volt Complaints

I will be driving on the road and randomly my vehicle will give me a loss of propulsion warning. This has happened many times on the highway where I’ve lost acceleration power quickly and have almost been involved in a futile accident as a result. My vehicle also randomly switches from electric to gas sometimes causing my car to jolt

This car is connected to Bouncie a device that detects when a car turns on and off, the speed, if break or acceletor are stepped on forcefully and any trips. Recently the device is detecting the engine is turned off but the car is showing no signs of struggling and its in full motion. This is new, I've tested the device in another car for two weeks hoping it was the device but I had no issues on the other vehicle. The images is just one of several occasions. The image shows green dot where car starts and red where car is turned off. However, I never turned off my car at the Demaree Rd that day. I feel like the car is losing power and starts back up while in motion.

I was driving on a road at roughly 50 mph when suddenly without warming, the screen and everything shut off and went black in the vehicle, and then immediately turned back on, this time with the engine light on. In the following seconds, the gas pedal completely stopped responding, and I had to coast to a stop at the side of the road. It was a dangerous spot on the road to have this happen. I was able to power the vehicle off, and then back on again, and the vehicle functioned normally immediately afterwards, with no engine light on.

Car experienced sudden loss of power while driving. Warning appeared 'Propulsion Power Reduced.' Was able to continue driving short distance home and parked. Attempted to recharge battery but it would not accept charge. I was able to restart car again with "Propulsion Power Reduced' and drove to dealer. Diagnosis: Body Control Module (BCM) failed. Unit was replaced. Vehicle drove normally for short period and issue repeated within one day. Returned to dealer. Issue resolved after second attempt.

The passenger presence sensor in the front passenger seat is malfunctioning and spare parts to replace it are not available from the manufacturer. The Chevrolet dealership has inspected and verified this issue, and the system is available for inspection upon request. This is the same issue that NHTSA investigated in the 2013 model described below. This sensor failure results in a check airbag signal and prevents the deployment of the passenger frontal and knee air bags, posing risk of serious injury to passengers. The PSS may develop a malfunction due to bunching of the sensor mat in the seat trench. The bunching of the sensor mat could cause the mat to repeatedly fold in the same location. Over time, the repeated folding can cause an increased resistance in the sensor mat. An increased resistance in the PSS sensor mat is detected as a fault in the air bag system diagnostic. If this fault is detected, a diagnostic trouble code will be stored in the air bag control unit and the air bag...