2004 Chevrolet Malibu Complaints

EPS went out, warning message for steering on message board. Cannot steer very easily. Have not taken to dealer due to not wanting to operate unnecessarily

I was driving to work with my son and sister in the car when the steering wheel suddenly got very tight and started jerking when I attempted to make a left or right turn. I then stopped at a gas station and as soon as I came to a complete stop the vehicle shut off before I could turn it off manually. I then attempted to turn the key on and start the vehicle but it would not turn over, it would only make a clicking sound. I called a friend that was close by to come and assist me so when they arrived I asked them to jump my vehicle off via jumper cables which did get my vehicle's engine to finally start. The car sounded very weak as if it was going to shut off again once we disconnected the jumper cables but it didn't shut off. Nothing was working inside the car or outside meaning I had no radio, no interior lights and nothing on my dash was working. The speedometer wasn't working, the rims Guage wasn't working, the temp Guage wasn't working nor was anything else working on my dash. The...

The contact owns a 2004 Chevrolet Malibu Classic. The contact stated that while stopped at a red light, the vehicle lost motive power and abnormal noises were heard coming from the dashboard. The contact attempted to restart the vehicle when the door locks began to lock and unlock inadvertently. The contact was able to restart the vehicle and drove the vehicle to a locksmith. The locksmith informed the contact that there was no failure with the ignition switch. The dealer was made aware of the failure but informed the contact that they could not repair the vehicle. The vehicle was not diagnosed nor repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 91,000.

The contact owns a 2004 Chevrolet Malibu. The contact stated while the vehicle was parked and the engine running the contact noticed that their front driver and passenger headlight were very low in both low beam and high beam and that the light eventually burned out. The contact inspected the vehicle and saw that the light bulb sockets for both the front driver side and passenger had melted. The contact stated the cause of the failure is the wiring behind the headlight assembly that is causing the headlight socket to melt. The contact replaced the headlight bulb sockets themselves with aftermarket parts to repair the failure, however, the failure persisted and reoccurred. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was unknown.

The power steering went out while driving. The car was being backed out of the driveway. The car had lights go off when it happened. Once the car was restarted power steering worked again. This problem has only occurred once as far as known. The steering was incredibly hard to move when the issue occurred. It is foreseeable that if issue happens at the wrong time on the freeway it could lead to injury or death of driver, passenger, or others outside the vehicle. If it happens at high speeds during a turn any number of serous damage or injuries could occur. The vehicle was taken to a mechanic who said a dealership would have the equipment properly diagnose the problem. If the mechanic did it himself he would have to replace several parts one a time and it might not be fixed. I will have my son take it to a dealership to look at it. Lights went off during the problem, but it is UNKNOWN which ones lit up. The lights went off, but since significant force had to be used to pull the wheel...