2011 Bmw 335i Complaints

The contact owns a 2011 BMW 335I. The contact stated that upon taking the vehicle to an independent mechanic for repair, he was informed that the camshaft bolts were damaged and required replacement. The vehicle was not taken to the dealer for a diagnostic test. The vehicle was not repaired. After investigating the failure, the contact related the failure to NHTSA Campaign Number: 23V707000 (Engine and Engine Colling), but the VIN was not included. The manufacturer was notified of the failure but referred the contact to the NHTSA Hotline for assistance. The failure mileage was 130,000.

I bought a BMW on November 3rd and within 48 hours on the 5th of November at 6:30 the engine seized while the car was driving when I took it to BMW they did a carfax on it, it said the car had 197,000 miles on it and the car was listed with 97,790 miles and the odometer still says 97,000 and the transmission is also slipping because it had 197,000 miles on it and the font headlights won't work.

BMW has made their early 2011-13 engines(n55) a defective engine, the problem I’ve been experiencing with these engines is there new engine system called the valvetronic system. If the something in the valtronic system goes bad and most likely does when you listen to bmw recommendation of changing oil every 10,000 it becomes very annoying to fix and can also lead to damaging the car ecu/dme so they built a car that would have problems and would also take out your car ecu which would make costly repairs

I have electrical error codes and I cant seem to find what it is not sure if its wiring.

Without any warning, the vehicle experienced a major engine failure while I was driving at about 70 mph on the highway. The vehicle immediately lost power and went into limp mode, making it impossible to safely maintain speed on a busy highway. Vehicle was towed to the dealership and it was determined that it had experienced a VANOS bolts failure on the intake side. Inspection of the failed VANOS bolts revealed that they were of the old design that BMW had issued a Recall for. Even though the Recall status for the vehicle in regard to the VANOS bolts indicates that it was completed, it appears the wrong components had been used in the repair. I have been informed that BMW has denied my request to have the recall done properly with the proper components.